Headlights; Changing The Bulb For The Low Beam - Skoda Rapid Owner's Manual

CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
■
amount of dirt reduces the working life of the light bulb). Use a clean cloth, nap-
kin, or similar.
When removing and installing the tail light make sure that the paintwork of the
■
vehicle and the tail light are not damaged.
Note
This Owner's Manual only describes the replacement of bulbs where it is possi-
■
ble to replace the bulbs on your own without any complications arising. Other
light bulbs should be changed by your specialist garage.
We recommend that a box of replacement bulbs is always carried in the vehicle.
■
Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
We recommend that the headlight settings are checked by a Škoda Service
■
Partner after replacing a bulb in the main or low beam.
Other LED diodes should be changed by your specialist garage.
■

Headlights

ä
First read and observe the introductory information and safety warn-
ings on page 159.
Bulb arrangement in the Halogen headlamp
Low beam
A
Main beam, separate daytime running lights, and parking light
B
Turn signal light (at the front)
C
160
Do-it-yourself
Fig. 126
Bulb arrangement: Halogen
headlight

Changing the bulb for the low beam

ä
First read and observe the introductory information and safety warn-
ings on page 159.
›
Remove the rubber cover
A
›
Remove the connector with the bulb by pulling it back in the direction of the
Ð
arrow with loosening movements
›
Remove the connector.
›
Insert a new light bulb in such a way that the fixing lugs of the bulb fit in the
recesses of the reflector.
›
Fit the connector.
›
Insert the rubber cover.
Ð
Fig. 127
Changing the bulb for the low
beam
» Fig. 126 » page 160.
» Fig. 127.
Ð