Recording A Tv Program - JVC 2A73501A User Manual

Recording a TV Program

Notes:
• Since the DVD/VCR has a built-in TV
tuner the TV set may be turned off when
recording. The TV set may only be used
to check for accurate program adjust-
ments or to monitor recordings.
• You can confirm on the TV-screen whether
you selected SP or LP. Press OSD to see the
status display. (see page 29)
• If you wish to watch the DVD playback
during the normal recording on VCR,
press DVD to change to DVD mode and
perform the DVD playback (see page
42).
28
Preparation:
• Turn ON the TV and set to the video input mode.
• Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then
press VCR to select the VCR mode. (The VCR indicator will light)
1
Load a blank cassette tape with the
erase prevention tab intact. (The
DVD/VCR will automatically turn
on.)
VCR
2
Select the program(e.g.29) you want to record with PR +/– or
number keys.
1~9 : e.g. 5 = press "5"
10~80 : e.g. 29 = press "2" and "9".
3
If a recording in Long Play mode is intended, press
SPEED) to display "LP". (see Note below)
4
On the VCR, press 2.
Or on the Remote, while holding 2,
press .
" " will appear on the screen for
about 4 seconds and "REC" will
appear on the display.
VCR
REC
If the erase prevention tab is removed, the tape will eject when
both the 2 and
To Stop Recording
Press 3.
VCR
To Stop Recording Temporarily
To stop a recording for a short
period of time press 4. Press this
button again if you want to resume
the recording.
VCR
REC
Attention:
A safety circuit turns the pause mode off automatically after 5
minutes, and the DVD/VCR will stop the recording mode.
VCR
are pressed for recording. (see p.22)
(TAPE