JVC WB-S681U Instructions Manual page 6

WB-S684U Outdoor Pendant Mount
Notes on Installation
● Consult your dealer on the installation location.
● We will not be responsible for any accidents that occur as a result of flawed installation.
● Pay due attention to the installation location and method.
● If the location is not strong enough, reinforce with a reinforcing board and check for safety before installing.
WB-S684U is an outdoor model.
WB-S684U is exclusively used for VN-V686WPU and
TK-C686WPE (For Europe).
1.
Remove the top cover from
the camera unit.
A
Remove the top cover fixing screws.
B
Rotate the top cover in anticlockwise
direction as shown on the right diagram.
C
Lift up and remove the top cover.
2.
Remove the camera unit
from the arm section.
Remove the connection fixing screws. (x3)
3.
Pull out the cables and
fall prevention wire
from the arm section.
CAUTION
Pull out the cables without damaging them.
4.
Remove the fall prevention wire.
Remove the screws and the fall prevention wire
that is mounted on camera unit.
Top cover
fixing screw
Arm section
Connection
2.
section
fixing screws
Wrench
(4 mm)
1.
Top cover
3.
Top cover
Camera unit
Top cover
Camera unit
4.
Fall prevention wire