Connecting To The Ac24 V Power Supply - JVC VN-C20 Instructions Manual

Connecting to the AC24 V power supply

Connect this product to the AC24 V power
supply when not using the PoE.
Caution:
● Make sure to select only one mode of
electrical supply. Connecting the power cord
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
● The unit is to be powered by an AC 24 V
power supply.
The AC 24 V power supply should conform to
the following:Class 2 only(For USA),Isolated
power supply only(For Europe and other).
1
Power
indicator
POWER VIDEO OUT
CAUTION: Do not use
PoE and AC24V together
Power cord
● To prevent misconnection and detachment of
cords, use a lug plate for connecting to the
terminal.
● When using 2-core VVF (Vinyl-insulated
vinyl-sheath cable), the connection distance
is as follows:(Reference value)
Maximum 90
extension
(m)
R1.0 and
Conduc-
tor Diam- above
eter (mm)
To
Power
2 G 2 1 2 1
ALARM
PUSH
10BASE-T/100BASE-TX
DO NOT CONNECT TO THE
TELEPHONE NETWORK
For USA
240 390
R1.6 and R2.0 and
above above
Warning
The rated power of this product is AC24 V 50
Hz/60 Hz. Make sure to use it with the correct
voltage.
Use an AC24 V supply that is isolated at the
primary end.
Supplying a power beyond the rated value
may result in failures and in the worst
scenario, smoking and fire.
Notes:
● In a system where multiple units of VN-C20
are used, turn on the power of only 1 unit to
configure the IP address settings via the
Internet Explorer. Upon doing so, turn on the
power of the second unit and configure
accordingly. Configure the camera settings
using the same procedure.
● Whenever duplication of IP addresses
occurs, disconnect VN-C20 units from the
LAN except 1unit. Access to VN-C20 may be
disabled for a short period of time (at least 10
minutes), unless you restore the power
supply of all network devices under the same
LAN environment.
15