Charging The Battery Pack; Starting And Stopping - Flymo 420 Original Instructions Manual

C
1
D
E
G

Charging the Battery Pack

Initial Charging Procedure
1. Use the charger indoors only.
2
2. Ensure the charger is not exposed to moisture. Keep
3. Attach the charger connector (C1) to the Battery Pack.
3
4. Plug the charger (C2) into a suitable household electrical
5. The red indicator lamp (C3) glows continuously during
6. Full charge will be achieved in 3 hours after which the indi-
Re-Charging the Battery Pack
1. Re-charge the Battery Pack as soon as the cutting power
2. Avoid running the Battery Pack into "deep" discharge, i.e.
1
3. Follow the procedure outlined in the Initial Charging
4. Charging the Battery Pack according to these instructions
Battery Pack Assembly (D)
1. Attach the Battery Pack as illustrated in Figure D, ensuring
2. To remove, press the two buttons (D1) on either side of the

Starting and Stopping

Before starting your Hedgetrimmer.
1.
To start your Hedgetrimmer
1.
2.
To stop your Hedgetrimmer
•
1.
the charger and the Battery Pack dry at all times. Keep
the charger well ventilated during charging.
wall socket and switch on.
charging.
cator lamp on the charger (C3) will turn to green. During
charging the charger becomes warm. This is normal and
means the charger is operating correctly.
of your trimmer begins to die and slow down.
avoid flattening the Battery Pack completely.
Procedure.
should ensure maximum battery life.
that it clicks into position and is located firmly.
Battery Pack and slide off.
F
Remove blade cover (E).
There are two switch levers fitted to your Hedgetrim-
mer.
Both switch levers need to be held in the operating
position (See Fig F) for the product to start.
Move Hedgetrimmer away from cutting area before
stopping.
To stop, release one of the switch levers.(Fig G)