Triple Zigzag Stitching; Triple Stretch Straight Stitching; Button Sewing - Zanussi ZAN2250 User Manual

TRIPLE ZIGZAG
TRIPLE ZIGZAG
(1) pattern selection dial:3, 3-8 (
(2) stitch length: M 1-2
(3) presser foot: zigzag
(4) thread tension disc:4-6
TRIPLE STRETCH STRAIGHT STRITCHING
TRIPLE STRETCH STRAIGHT STRITCHING
(1) pattern selection dial: 1 or 2
(2) stitch length: (1)-(8)
(3) presser foot: zigzag
(4) thread tension disc: 4-6
BUTT ON SEWING
BUTT ON SEWING
(1) Stitch selection dial: 3); 3-5 (aslong as fit
for button sewing) (2) Stitch length: could be
adjusted to any figure (3) Stitch wide: making
presser foot for button sewing (4) Presser
foot: button sewing (5) Tread tension disk
presser: 1-3
(6) Tape the button over the marked position
(See page 11)
13.09.2006 13:33 Uhr
The stitch is used for synthetic materials and other materials that get folds easily.
It also suits over-lock so as to avoid threads falling apart. It is fit for sewing elastic
bends and darning. A strip of hemming-stitch with 1.5 cm is to be left.
Cut off the strip of hemming-stitching after sewing.
Two stitches forward and then one stitch backward will make the stitching firm. Prior to
stitching garment pıeces, make a sample by using pins. Such stitches are most
suitable for sewing crotches.
Align both holes of the button with groove slots while placing the left button hole
directly under the needle point. Low presser foot
-Turn pattern selection dial -turn the stitch width just up to the top of right button
hole. Make 5 stitches approximately and raise the needle.
To get a thicker button handle, cut the thread wıth 20 cm left. Bring the upper thread
down through the button hole and wind it around the button handle for several
turns. Draw the thread to the back and make a knot.
Instruction: raise the teed dog again after sewing buttons.
Seite 13
11