R R E E C C E E I I V V E E R R I I N N S S T T A A L L L L A A T T I I O O N N; Outdoor Installation - Toro TMR-1 User Manual

Maintenance remote
Table of Contents

Advertisement

R R e e c c e e i i v v e e r r I I n n s s t t a a l l l l a a t t i i o o n n

Before using your TMR-1 remote control system for the
first time, the following procedures must be completed:
Charge the transmitter batteries for a minimum of
8 hours.
Install and connect the receiver plug assembly and
receiver unit per the instructions provided.
Test the installation to confirm proper signal reception
and remote operation.
For maximum remote control performance and operating
range, select an installation site for the receiver using the
following guidelines:
The mounting location wall is constructed primarily of
wood or other non-metallic materials.
Stuccoed walls, metal buildings and large metal objects
are avoided.
The receiver is located as high above the controller as
possible.
The antenna is free of contact and aligned perpendicular
to the horizon.
T T h h e e T T M M R R - - 1 1 r r e e c c e e i i v v e e r r p p l l u u g g a a s s s s e e m m b b l l y y i i s s s s p p e e c c i i f f i i c c a a l l l l y y
d d e e s s i i g g n n e e d d f f o o r r t t h h i i s s s s y y s s t t e e m m . . T T h h e e T T o o r r o o E E Z Z - - R R e e m m o o t t e e a a n n d d
I I r r r r i i t t r r o o l l K K w w i i k k S S t t a a r r t t r r e e c c e e i i v v e e r r p p l l u u g g s s a a r r e e n n o o t t c c o o m m p p a a t t i i b b l l e e . .
The receiver plug mounting bracket should be secured to
an inside wall within 4' of the controller (the connecting
cable is approximately 6' in length). Alternately, when an
outdoor installation is preferred, the receiver plug can be
removed from the mounting bracket and installed into a
threaded
" PVC pipe fitting.
1
2
I I n n d d o o o o r r I I n n s s t t a a l l l l a a t t i i o o n n
1 – Position the receiver plug assembly on the wall within
4' of the controller, as high as practical.
hole in the center of the plug must be pointing down.
6 6
T T M M R R - - 1 1
R R e e c c e e i i v v e e r r I I n n s s t t a a l l l l a a t t i i o o n n
The alignment

Advertisement

Table of Contents
loading

Table of Contents