T T R R O O U U B B L L E E S S H H O O O O T T I I N N G G; Setup Information - Toro TMR-1 User Manual

Maintenance remote
Table of Contents

Advertisement

T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g

The following troubleshooting symptoms and solutions
are provided to help resolve basic problems that may arise
during setup and initial operation of the TMR-1 remote
control system. If the problem cannot be resolved using this
information, contact a Toro Customer Service representative
at 1-800-664-4740 for assistance. Normal office hours are
Monday–Friday, 7:30 a.m.– 4:00 p.m., PST.
T T h h e e c c o o n n t t r r o o l l l l e e r r s s t t a a t t i i o o n n d d o o e e s s n n o o t t t t u u r r n n o o n n . .
S S o o l l u u t t i i o o n n
O
Verify the handheld transmitter and receiver are set to
the same address code. Confirm the receiver Activity
monitor momentarily flashes Red when a command
is sent from the transmitter. If the Activity monitor
continues to flash only Green, communication is not
established. Refer to pages 13–15 for address code

setup information.

T T h h e e c c o o n n t t r r o o l l l l e e r r s s t t a a t t i i o o n n n n u u m m b b e e r r i i s s h h i i g g h h e e r r t t h h a a n n c c a a n n
b b e e s s e e l l e e c c t t e e d d o o n n t t h h e e t t r r a a n n s s m m i i t t t t e e r r . .
S S o o l l u u t t i i o o n n
O
The transmitter station number range is adjusted too
low for your controller application. Refer to page 15 for
the adjustment procedure.
T T h h e e c c o o m m m m u u n n i i c c a a t t i i o o n n r r a a n n g g e e i i s s v v e e r r y y s s h h o o r r t t . .
S S o o l l u u t t i i o o n n 1 1 o o f f 2 2
O
Change the receiver location slightly. Try increasing the
installed height and/or moving the receiver slightly left or
right. Sometimes small changes can result in a substantial
increase in reception. Make sure the receiver is not located
within 3' of any large metal object or metal stud. Metal
objects below the receiver are generally not a problem,
whereas metal objects above the receiver can often
decrease reception and overall performance.
1 1 8 8
T T M M R R - - 1 1
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g

Advertisement

Table of Contents
loading

Table of Contents