Table of Contents
Advertisement
Before you Start
1. Ensure pump is isolated.
2. Position lever in central, i.e. mixer, off
location.
COMET ROMA SINGLE LEVER MIXER TAP
Required tools
- Pipe wrench
- Cross-point
screw-driver
- Flat-bladed
screw driver
inside the
Tools
handle.
Step 1
- Remove the
marker cap
Step 2
- Remove the
screw from
the control
1
knob
- Pull the
microswitch
out of the
control knob
2
3
4
Step 3
- Remove the dome
- Remove the small
screw between
cartridge and closure
Step 4
5
- Remove the snap ring
(small plastic piece)
Step 5
- Remove the snap ring
with the Pipe wrench
(Turn left or right)
Step 6
- Pull the cartridge out of
6
the housing
- Remove the old
microswitch
Services
Step 7
- Put in the cable from
the new microswitch.
You need 50 mm cable
length over the top of
the housing.
Step 8
7
- Insert the cartridge.
Step 9
- Refit the component parts in reverse
sequence.
Steps 5 to 1
8
9
33
- Quick Links:
- Electrical Equipment
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Vehicle and is the answer not in the manual?
Questions and answers
No power to fridge lights and water pump. Power to everything else
The likely cause of no power to the fridge lights and water pump in a Swift vehicle is that the 12V power supply is not active. The fridge requires a 12V supply for control functions, and the car engine must be running for the fridge to operate in 12V mode. Additionally, if the 12V power switch on the control panel or remote control is turned off, this can also cut power. Make sure the 12V power is switched on and that the car engine is running when needed. If using a remote control, ensure it is working or revert to manual switches.
This answer is automatically generated
@Mr. Anderson I am on a site with 240 on car is not connected