The Towing Code
ROAD LIGHTING
For your information the wiring diagram of
the 12N and 12S connectors is shown
opposite. These should be checked regularly
and if in any doubt a qualified electrician
consulted.
Some European cars may be equipped with
Volta, Jeager, West or multi-con sockets, an
adaptor or replacement sockets may be
required. If so consult your dealer or qualified
electrician.
The wiring allocations were changed in 1998
and it is important that you check the car to
caravan connections are compatible prior to
coupling up to the car.
WARNING: Always disconnect the
electrical connector between the
towing vehicle and the caravan before
connecting a low voltage supply to the
caravan (mains) and before charging
the battery (EN 1648-1).
• All road lights must be in working order.
• Lenses and reflectors must be in good
condition
• Bulbs must be of correct wattage for the
application (see Service handbook).
14
12N AND 12S VIEWED FROM REAR OF PLUG
12N (BLACK)
TERMINAL COLOUR
12N PLUG
1
YELLOW
L/H INDICATOR
2
BLUE
REAR FOG LAMP
3
WHITE
COMMON RETURN (1-7)
4
GREEN
R/H INDICATOR
5
BROWN
R/H SIDE TAIL & No PLATE LIGHT
6
RED
STOP LAMP
7
BLACK
L/H SIDE TAIL & No PLATE LIGHT
VOLTA/JEAGER & MULTICON FEDER 13 PIN PLUGS (viewed from rear)
VOLTA/JEAGER
PIN NO
COLOUR
DESCRIPTION
1
YELLOW
LEFT FLASHER
2
BLUE
FOG HAZARD LIGHT
3
WHITE
EARTH FOR 1-8
4
GREEN
RIGHT FLASHER
5
BROWN
RIGHT TAIL LIGHT
6
RED
STOP LIGHTS
7
BLACK
LEFT TAIL LIGHT
8
ORANGE
REVERSE LIGHTS
9
BROWN/BLUE
CAR +
10
BROWN/RED
FRIDGE
11
WHITE/BLACK
EARTH FOR 10
12
NOT YET ALLOCATED
13
WHITE/GREEN
EARTH FOR 9
12S (GREY)
TERMINAL COLOUR
12S PLUG
1
YELLOW
REVERSING LIGHT
2
BLUE
NO ALLOCATION
3
WHITE
NEGATIVE PIN 4
4
GREEN
CONTINUOUS POWER SUPPLY
5
BROWN
NO ALLOCATION
6
RED
FRIDGE
7
BLACK
RETURN FOR FRIDGE
MULTICON
WEST
FEDER 13K
PIN NO
COLOUR
DESCRIPTION
1
YELLOW
LEFT FLASHER
2
BLUE
FOG HAZARD LIGHT
3
WHITE
EARTH FOR 1-8
4
GREEN
RIGHT FLASHER
5
BROWN
RIGHT TAIL LIGHT
6
RED
STOP LIGHTS
7
BLACK
LEFT TAIL LIGHT
8
ORANGE
REVERSE LIGHTS
9
BROWN/BLUE
CAR +
10
BROWN/RED
FRIDGE
11
WHITE/BLACK
EARTH FOR 10
12
NOT YET ALLOCATED
13
WHITE/GREEN
EARTH FOR 9
TUBES
PINS
PINS
STRIPS
Need help?
Do you have a question about the Vehicle and is the answer not in the manual?
Questions and answers
No power to fridge lights and water pump. Power to everything else
The likely cause of no power to the fridge lights and water pump in a Swift vehicle is that the 12V power supply is not active. The fridge requires a 12V supply for control functions, and the car engine must be running for the fridge to operate in 12V mode. Additionally, if the 12V power switch on the control panel or remote control is turned off, this can also cut power. Make sure the 12V power is switched on and that the car engine is running when needed. If using a remote control, ensure it is working or revert to manual switches.
This answer is automatically generated
@Mr. Anderson I am on a site with 240 on car is not connected