Circuit Description - Kenwood TK-3102G Service Manual

Uhf fm transceiver
Table of Contents

Advertisement

TK-3102G
1. Frequency Confi guration
The receiver utilizes double conversion. The first IF is
38.85MHz and the second IF is 450kHz. The fi rst local oscil-
lator signal is supplied from the PLL circuit.
2. Receiver
The receiver is double conversion superheterodyne, de-
signed to operate in the frequency range of 450 to 470MHz
(K, M), 470 to 490MHz (K2, M2).
The frequency confi guration is shown in Fig. 1.
1) Front-end RF Amplifi er
An incoming signal from the antenna is applied to an RF
ANT
D102, D103
ANT SW
TUNE
APC
IC403
MPU
2) First Mixer
The signal from the RF amplifi er is heterodyned with the
fi rst local oscillator signal from the PLL frequency synthe-
sizer circuit at the fi rst mixer (Q202) to create a 38.85MHz
fi rst intermediate frequency (1st IF) signal. The fi rst IF signal
is then fed through two monolithic crystal filters (MCFs :
XF201) to further remove spurious signals.
3) IF Amplifi er
The fi rst IF signal is amplifi ed by Q201, and then enters
IC200 (FM processing IC). The signal is heterodyned again
with a second local oscillator signal within IC200 to create
a 450kHz second IF signal. The second IF signal is then fed
6

CIRCUIT DESCRIPTION

ANT
RF
ANT SW
AMP
PA
TX
AMP
AMP
Fig. 1 Frequency confi guration
BPF
RF AMP
BPF
L208~L211
Q203
L214, L203, L204
Fig. 2 Receiver section confi guration
The PLL circuit in the transmitter generates the neces-
sary frequencies. Fig. 1 shows the frequencies.
CF
450kHz
MCF
IF SYSTEM
38.4MHz
38.85MHz
X3
multiply
RX
PLL
VCO
TX
amplifier (Q203) after passing through a transmit/receive
switch circuit (D102 and D103 are off) and a 3-pole LC fi lter.
After the signal is amplifi ed (Q203), the signal is fi ltered by
a band pass fi lter (a 3-pole LC fi lter) to eliminate unwanted
signals before it is passed to the fi rst mixer.
The voltage of these diodes are controlled by to track the
MPU (IC403) center frequency of the band pass fi lter. (See
Fig. 2)
MIXER
MCF
IF AMP
Q202
XF201
Q201
TCXO
1st Local OSC
(PLL)
through a 450kHz ceramic fi lter (CF200) to further eliminate
unwanted signals before it is amplifi ed and FM detected in
IC200.
4) AF Amplifi er
The recovered AF signal obtained from IC200 is ampli-
fi ed by IC300 (1/4), fi ltered by the IC300 low-pass fi lter (2/4)
and IC300 high-pass fi lter (3/4) and (4/4), and de-emphasized
by R303 and C306. The AF signal is then passed through a
WIDE/NARROW switch (Q303). The processed AF signal
passes through an AF volume control and is amplifi ed to a
suffi cient level to drive a loud speaker by an AF power am-
plifi er (IC302).
AF
SP
AMP
TCXO
12.8MHz
MIC
MIC
AMP
CF200
AF PA AMP
IC302
AF AMP
IF, MIX, DET
LPF, HPF
IC200
IC300
X3
multiply
Q1
WIDE/NARROW SW
Q303
SP

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents