Installing The Pen Tray; Mounting The Guest Computer Harness - SMART Board 685ix Installation Manual

To install the pen tray
To mount the guest
computer harness
on the wall
14 | I N S T A L L IN G Y O U R S M A RT B O A R D 6 85 IX P R E MI U M I N T E R A C T I V E
WH ITE BOARD S YS T E M

Installing the pen tray

1. Position the pen tray in line with the two
L-shaped metal brackets, and then slide it
toward the wall until it rests snugly against the
bottom frame of your interactive whiteboard.
The pen tray clicks into place.
2. Route the control module's modular I²C cable
through the cable management channel under
the lower-right end of the pen tray, and then
insert its connector into receptacle 1.
3. Press the cable into the cable management
channel on the bottom of the tray.
This step protects the modular cable's RJ11
connector from damage if the pen tray is
removed without first disconnecting the cable.
4. Place the four pens and the eraser into their
respective slots in the pen tray.

Mounting the guest computer harness

When the guest computer harness isn't in use, you can magnetically attach it to the
wall beside the interactive whiteboard.
1. Drill a 1/4" (6 mm), 1 3/4" (45 mm) deep hole in
the wall approximately 3" (8 cm) to the right of
interactive whiteboard frame near where the
guest computer harness exits the side of the
wall mount.
NOTE
Position the hole so the harness doesn't
interfere with the SBA speaker or cables.
~3"
(8 cm)