Cub Cadet 552 Operator's Manual page 8

Securing Control Cable
WARNING:
avoid contact with all sharp edges and hot surfaces.
Such contacts damage the cable and render the
controls inoperative.
1. Press the stud found inside the snap fitting into the hole
found on the left side of the upper handle, as shown in
Figure 3-3.
1
Snap
Fitting
2
2. Push the snap fitting down on the handle to secure it into
place.
Securing Blade Depth Control Cable
Unwrap the blade depth control cable and route it up the right
side of the handle.
1. Pull the depth control lever out of the first position of the
depth control bracket.
2. Push lever all the way forward.
3. Release lever into last position of bracket.
4. Hook the Z end of the depth control cable into the hole on
the depth control lever as shown in Figure 3-4.
8 S 2— A
ection SSembly
The cable must be routed properly to
Stud
Upper
Handle
Figure 3-3
& S -U
et p
2
3
Figure 3-4
Starter Rope
1. Locate the rope guide and wing knob found in the manual
bag. Using the wing knob, secure but do not tighten the
rope guide to the right side of the upper handle as shown
in Figure 3-5.
1
4
Figure 3-5
1
4
2
3
5