Fault Codes - Hotpoint Ariston AAQCF81U IT Service Information

Indesit Company

FAULT CODES

In the event of a fault being detected by the
electronics, a code will appear in the LCD
display.
These codes are listed in the following table.
Please Note:
• Components with a low resistance to
Earth may cause erroneous faults or
loss of the display.
• Always check relevant wiring and
connector blocks security before considering replacing the modules.
Code
F01 Motor runs continually
F02 No Drum Motor Action
F03 Front NTC open or short
circuit
F04 No pump
F05 Pump continually running
F06 Not used
F07 Not used
F08 Compressor fault
F09 Error with set up file
F10 Not used
F11 Same as F04
continued...
Service Manual UK
Fault Check for Corrective Action
Check module connection J3 for sign of shorting.
Replace Module.
Check security of module connection J3.
Check motor for open circuit.
Check security of module connection J12.
Check Resistance of NTC (see page 15 for reading).
Check security of module connector J5.
Check float operation & switch.
Check pump / wiring for open circuit
Check security of wiring module J5.
Module fault - Replace module.
Check security of module connection J11 & J4.
Check wiring to compressor via capacitor.
Check compressor for open circuit.
Relay fault on module - replace module.
Check connection between interface and control module J9
Check programme file and re - load as required.
EEPROM fault on module - Replace module.
22 of 36
Example of a Fault Code
All 4 options button lights and the Start/Pause
light will flash when a Fault Code is displayed.
English