Dubbing To Or From A Video Unit Equipped With A Dv Connector - JVC GR-DVM90 Instructions Manual

Lock Button
POWER Switch
To DV IN/OUT
Core filter
DV cable
(optional)
Core filter
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Set the POWER Switch to "
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press START/STOP to engage the Record-Pause mode. "DV IN" appears on the screen.
5. Press START/STOP to start recording. "DV IN" changes to "
6. Press START/STOP again to engage the Record-Pause mode. "
NOTES:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signals are output from the AV OUT connector.
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
1
Open the
connector
cover.
2
3
4
NOTES:
It is recommended to use the AC Power Adapter/ Charger as
the power supply instead of the battery pack (
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press the
buttons on both units.
For Digital Dubbing, this camcorder can be connected only
to one device at a time. This camcorder can also be used as
a recorder.
If a blank portion or disturbed image is played back on the
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
Even though the DV cable is connected correctly, some-
times the image may not appear in step 3. If this occurs, turn
off the power and make connections again.
If "Playback Zoom" (
(
only the original playback image recorded on the tape is
output from the DV IN/OUT connector.
When using a DV cable, be sure it has a core filter
attached. The core filter reduces interference.
" while pressing down the Lock Button located on the switch.
pg. 29).
Make sure the camcorder's power is off.
Connect the camcorder to your video unit equipped
with a DV connector using a DV cable as shown in
the illustration.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
pg. 68), "Playback Special Effects"
pg. 69) or "Snapshot" is attempted during playback,
pg. 43)
".
DV IN
" returns to "DV IN".
DV IN
63
EN
pg. 9).