Turning On In The Event Of A Power Failure; Regulating; Turning Off - Miele KM 3010 Operating And Installation Instructions

Operation

Turning on in the event of a power failure

Regulating

Turning off

14
If there is a power loss, you can ignite the flame manually,
e.g. with a match.
^ Press the burner control knob and turn it
counterclockwise to the largest flame symbol.
^ Keep the knob pressed and ignite the escaping gas-air
mixture with a match.
^ Keep the knob pressed for a further approx. 5 - 10 seconds
and then release it.
The flame should be regulated so that it never protrudes
beyond the pot. Since the outer part of the gas flame is much
hotter than the center of the flame, the flame tips should
remain under the base of the pot. Protruding flame tips give
off unnecessary heat into the air and can damage pot
handles and increase the risk of burning.
The burner can be continuously regulated between the
highest and lowest flame.
^ To switch from the high to the low setting, turn the burner
control knob clockwise until resistance is felt. Press the
knob down until you pass the stop, and release the
pressure and set the cooktop the desired setting.
^ To switch from the low to the high setting, turn the burner
control knob counterclockwise until resistance is felt. Press
the knob down until you pass the stop, and release the
pressure and set the cooktop the desired setting.
^ Turn the burner control knob clockwise to "ß".
The gas supply is stopped and the flame goes out.
Do not turn the burner control knob clockwise beyond "ß".