Dubbing Images Recorded On A Tape To The Built-In Memory - JVC GR-DVL505 Instructions Manual

MODE Button
SNAPSHOT Button
MENU/
BRIGHT
Wheel
V I D E O M EN U
1 R E T U R N
S O U N D M O D E
1 2 B I T M O D E
S Y N C H R O
R E C M O D E
C O P Y O N
Play/Pause Button (4/6)
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
Display
Dubbing Images Recorded On A Tape To
Power Switch
The Built-in Memory
Images can dubbed from a tape to the camcorder's built-in
memory.
1
Lock Button
2
3
4
5
6
7
8
NOTES:
6
SP
Load a cassette ( pg. 12).
Set the VIDEO/DSC Switch to "VIDEO", then set the
Power Switch to "
Lock Button.
Press the MENU/BRIGHT wheel. The Menu Screen
appears. Rotate it to select "
MENU" appears.
Rotate the MENU/BRIGHT wheel to select
" COPY" and press it. The Sub Menu
appears. Rotate it to select "ON" and press it.
Selection is complete.
Rotate the MENU/BRIGHT wheel to select "1RE-
TURN" and press it twice. The normal playback
screen resumes.
To select a video image to be dubbed, start playback
by pressing 4/6. At the moment you find the image
you wish to dub, press it again to engage Still
Playback.
Press MODE to select the Snapshot mode to use for
dubbing the image to the built-in memory.
To start dubbing, press SNAPSHOT. The selected
image is stored in the built-in memory.
•" " blinks during dubbing.
If SNAPSHOT is pressed in step 8 when the built-in
memory is full, the message "COPYING FAILED"
appears.
If an image recorded on the tape using the WIDE mode
( pg. 26) is dubbed to the camcorder's built-in
memory, the WIDE mode identifying signal is not
dubbed with it.
To use Playback Special Effects with a video image you
wish to dub, perform up to step 8 using the remote
control (provided) ( pg. 53).
EN
" while pressing down the
" and press it. "VIDEO
49