Cub Cadet LTX 1140 Operator's Manual page 28

6. To place the new belt, begin by routing the belt around the
two outer spindle pulleys as shown in Fig. 7-8.
7. Then route the belt around the two deck idler pulleys as
shown in Fig. 7-8.
8. Retighten the belt keeper rod loosened earlier.
9. Remount the belt guards removed earlier.
10. Reinstall the deck, making sure the belt remains routed
around the pulleys as instructed.
11. Pull the right side of the belt, and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-9.
12. While holding the belt and pulley together, rotate the
pulley to the left (See Fig. 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
28 S 7— S
ection ervice
Figure 7-8
Pto Belt
Rotate
Pulley
Figure 7-9