Touch Panel / Touch Pen Preparations; Connecting The Touch Pen Adapter; Touch Pen Preparations; Computer Preparations - Sharp PN-70TA3 Operation Manual

Touch Panel / Touch Pen Preparations

Connecting the touch pen adapter

To use the touch pen, insert the touch pen adapter into the
touch pen adapter port on the monitor.
Touch pen
adapter port
Touch pen
adaptor

Touch Pen Preparations

nInserting the battery
1. Remove the battery cap.
2. Open the cover and insert the supplied battery (LR-03
("AAA" size)) into the touch pen.
Check the plus (+) and minus (-) markings on the inside
of the touch pen and insert the battery in the correct
orientation.
3. Replace the cover and battery cap.
TIPS
• The supplied battery (LR-03 ("AAA" size)) may be
exhausted in a short time, depending on how it was stored.
• If the touch pen will not be used for an extended time,
remove the battery from the touch pen.
• For the battery, use an alkaline battery.

Computer preparations

To use the touch panel and the touch pen, install the software
below.
WHITEBOARD
Computer
To install the software, see the manual for each.

Calibration

Calibration is used to perform position alignment so that the
Touch pen
mouse cursor moves to the correct position when the screen
adapter screw
is touched.
(antitheft)
• If you will be using the touch panel with a computer,
perform calibration from the Touch Panel Settings Tool.
For details, see the Touch Panel Settings Tool Operation
Manual.
• To perform calibration on the WHITEBOARD, follow the
steps below.
1. Switch the input to WHITEBOARD.
2. Touch the launch button.
2
1
Battery cap
The launcher appears.
3. Touch [Setting].
You will be prompted to enter a password.
4. Enter the password and touch [OK].
Enter the password set in the Admin Password. If a
password is not set, enter "00000".
5. Touch [Admin Settings] and [Calibration].
6. Follow the instructions on the screen to perform
calibration.
The software is already installed.
• Touch Panel Settings Tool
• Touch Pen Utility
• Pen Software
Launch button
19
E