Kubota L3200 Workshop Manual page 33

L3200, WSM
Checking Engine Start System
CAUTION
• Do not allow anyone near the tractor while testing.
• If the tractor does not pass the test do not operate the
tractor.
Preparation before testing
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
Test : Switch for the range gear shift lever
1. Sit on the operator's seat.
2. Shift the range gear shift lever to "L", "H" or "R" position.
3. Depress the clutch pedal fully.
4. Disengage the PTO gear shift lever.
5. Turn the key to "START" position.
6. The engine must not crank.
Test : Switch for the PTO gear shift lever
1. Sit on the operator's seat.
2. Engage the PTO gear shift lever.
3. Depress the clutch pedal fully.
4. Shift the range gear shift lever to "NEUTRAL" position.
5. Turn the key to "START" position.
6. The engine must not crank.
(1) Clutch Pedal
(2) PTO Gear Shift Lever
Checking Wheel Mounting Screws and Nuts Tightening Torque
CAUTION
• Never operate tractor with a loose rim, wheel or axle.
• Any time screws and nuts are loosened, retighten to
specified torque.
• Check all screws and nuts frequently and keep them tight.
1. Check the wheel mounting screws and nuts regularly especially
when new. If there are loosened, tighten as follows.
Front wheel mounting
screw and nut or lug nut
Tightening torque
Rear wheel mounting
screw and nut
(1) Front Wheel Mounting Screw and
Nut or Lug Nut
G-17
G GENERAL
(3) Range Gear Shift Lever
W1031944
137 N·m
14.0 kgf·m
100 ft-lbs
215 N·m
22.0 kgf·m
160 ft-lbs
(2) Rear Wheel Mounting Screw and
Nut
W1033386
KiSC issued 12, 2006 A