Mitsubishi Electric GB-50A Installation Manual page 11

20 (13/16)
CAUTION
● DIN rail attachment must be fixed at four points on the unit using two attachments.
● To secure the strength, screw pitch of 200mm(7.88inch) or less is required when DIN rail is fixed
on the control board.
● Use GB-50A in a place where it receives no vibrations. Use studs as necessary to fix GB-50A.
Installation and de-installation on DIN rail
1) Installation
Put the upper side of attachment on DIN rail, and push the bottom of the unit in the direction of the arrow
shown in the figure below.
2) De-installation
Push the unit downwards, and pull it in the direction of the arrow shown in the figure below.
50 (2)
Fig.5-6
Fig.5-7
Step1
Fig.5-8
20 (13/16)
CAUTION
● Check that the attachment is fixed securely to
the DIN rail.
10
20 (13/16)
DIN rail (35mm)
unit:mm(in)
Step2