Yamaha E115A Owner's Manual page 95

q
w
e
r
y
t
000357
602053
EMU00976
Removing the Propeller
1) Straighten the cotter-pin 1 and pull it
out using a pair of pliers.
2) Remove the propeller nut 2, washer 3
and spacer 4.
3) Remove the propeller 5 and thrust
washer 6.
EMU01560
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise
the lower case and propeller boss may
be damaged.
8 Be sure to use a new cotter pin and
bend the ends
Otherwise, the propeller could come
off during operation and be lost.
1) Apply Yamaha
Corrosion resistant grease to the pro-
peller shaft.
2) Install the thrust washer and propeller
on the propeller shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut further
to align it with the hole.
E
over securely.
Marine grease or
4-24