Start-In-Gear Protection - Yamaha E115A Owner's Manual

1-9
13 x 17 - K
q w e
000933
14-1/2 x 17 - M
q w e
602022
13-3/4 x 17 - ML
q w e
602033
q
000376
Yamaha dealers stock a range of pro-
pellers, and can advise you and install a
propeller on your outboard that is best suit-
ed to your application.
NOTE:
At full throttle and under a maximum boat
load, the engine's rpm should be within the
upper half of the full throttle operating
range, as listed in "SPECIFICATIONS" on
page 4-1. Select a propeller which fulfills
this requirement.
If operating under conditions which allow
the engine's rpm to rise above the maxi-
mum recommended range (such as light
boat loads), reduce the throttle setting to
maintain the rpm in the proper operating
range.
1 Propeller diameter (in inches)
2 Propeller pitch (in inches)
3 Type of propeller (propeller mark)
Refer to the section "CHECKING PRO-
PELLER" for instructions on propeller
removal and installation.
EMU01208

START-IN-GEAR PROTECTION

Yamaha outboard motors which have the
pictured label 1 affixed to them or Yamaha
approved remote control units are equipped
with start-in-gear protection device(s). This
feature permits the engine to be started
only when it is Neutral. Always select
Neutral before starting the engine.
E