Table of Contents
Advertisement
------ADJUSTING THE ANTENNA COUPLER - - - - - -
1. Put the Matching Selector Switch in the DIRECT position (to connect the antenna directly
to the receiver.)
2. Set the Coupler Band Selector to the desired frequency band.
3. Turn the radio receiver ON, and tune it to a desired station.
4. Rotate the Antenna Coupler Matching Selector Switch to the "A" position.
S. Adjust the Coupler's Tuning Control for best reception.
6. Repeat Step S for each of the other Matching Selector Switch positions "B". "C" and
"0", in order. Of the four positions, select the one that provides the best reception.
7. After determining the best position, further adjust the radio receiver's and the Antenna
Coupler's controls.
- - - - - - - - - HELPFUL HINTS - - - - - - - - -
•
This antenna is for reception only, it cannot be used for transmission purposes.
•
To avoid damage to the cabinet and to the parts inside, do not expose the coupler to
direct sunlight, heating equipment. hot-air blowers, etc.
•
To clean the cabinet, wipe it with a soft cloth, dampened in diluted soap and water.
Do not use benzine, thinner, abrasive powders, etc.
•
This coupler does not require any batteries or AC line power to operate. It contains
tuning circuits that operate without the need for any tubes or transistors.
PRODUCT SERVICE
Should this product require service, please contact anyone of our Regional Parts
Depots. Their addresses are listed on the warranty card. For your convenience,
fill in the "Customer's Record" portion of the warranty card and keep it for future
reference.
Panasonic Company
Division of Matsushita Electric Corporation of America
One Panasonic Way, Secaucus, New Jersey 07094
Matsushita Electric of Hawaii, Inc.
320 Waiakamilo Road, Honolulu, Hawaii 96817
Advertisement
Table of Contents
