Disassembly For Repair - Kenwood TK-361SA Service Manual

• The source Unit and target Unit must be of the same
model type and destination in order for Clone to operate.
• Clone mode cannot be accessed if "Super Lock" is acti-
vated.
• Electronic interface may cause a failure in data transfer
during Wireless Clone, such as when waveforms or elec-
tromagnetics are being performed at the workbench.
• Clone mode can be used ONLY by the authorized service
personnel.
• The Clone mode setting must be confi gured as "Disable"
before being delivered to the end-user.
• To clone, replace the antenna from both the source trans-
ceiver and the target transceiver with a dummy load.
• The transmit output power is automatically set to Low in
Clone mode.
■ Removing the case assembly from the chassis
1. Remove the volume knob q and channel knob w.
2. Remove the two screws e.
3. Lift and remove the chassis from the case assembly r.
(Use a fl at-blade screwdriver to easily lift the chassis.)
REALIGNMENT

DISASSEMBLY FOR REPAIR

Clone Frequency Table
Table number
1
2
3
4
5
■ Removing the TX-RX unit from the chassis
1. Remove the packing t from the SP/MIC jack of the TX-
RX unit.
2. Remove the eleven screws y fi xing the TX-RX unit.
3. Remove the fi xing bracket u of the SP/MIC.
4. Remove the solder of the antenna terminal with a solder-
ing iron i.
5. Remove the solder of the positive terminal with a solder-
ing iron o.
Note: You can remove the TX-RX unit from the chassis
without removing the solder at the positive terminal.
However, in this case, you can not attach the packing
(G53-1605-03) that is on the positive terminal to the
chassis in assembling. So, it is advisable to remove the
solder on the positive terminal fi rst.
6. Remove the FPC from the fl at cable connector !0 .
7. Lift and remove the TX-RX unit from the chassis !1 .
TK-361SA
Frequency (MHz)
463.9750
464.1250
464.1750
464.3250
464.3750
5