General - Kenwood TK-361SA Service Manual

TK-361SA
Document Copyrights
Copyright 2008 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
Destination
M
2
Number Of CH Frequency No. / Frequency
CH1 463.975MHz
CH2 464.125MHz
8 channel CH3 464.175MHz
CH4 464.325MHz
CH5 464.375MHz

GENERAL

INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced tech ni -
cians familiar with similar types of commercial grade com-
mu ni ca tions equipment. It contains all required service
in for ma tion for the equipment and is current as of the pub-
lication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are is sued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment in for ma-
tion, the full part identifi cation number should be in clud ed.
This applies to all parts : components, kits, or chassis. If the
part number is not known, include the chassis or kit number
of which it is a part, and a suffi cient description of the re-
quired component for proper identifi cation.
PERSONAL SAFETY
The following precautions are recommended for personal
safety:
• DO NOT transmit until all RF connectors are verifi ed se-
cure and any open connectors are properly terminated.
• SHUT OFF and DO NOT operate this equipment near
elec tri cal blasting caps or in an explosive atmosphere.
• This equipment should be serviced by a qualifi ed tech ni -
cian only.
SERVICE
This transceiver is designed for easy servicing. Refer
to the sche mat ic diagrams, printed circuit board views, and
align ment procedures contained within.
Factory default CH setting
CH1 463.975MHz / QT 94.8Hz
CH2 464.125MHz / QT 88.5Hz
CH3 464.175MHz / QT 103.5Hz
CH4 464.325MHz / QT 79.7Hz
CH5 464.375MHz / QT 107.2Hz
CH6 OFF
CH7 OFF
CH8 OFF
RF power output
2W