GE NX-10 User Manual page 35

Installer The person who installs and programs
the system.
Keypad sounder An audible signal that is sounded by the
keypad. This can be programmed to
sound at various times.
Master Code A menu option that assigns a master
code to the selected user. This is an arm/
disarm code that can program other
user codes provided it has access to the
same partitions as the user code.
Master mode The mode in which a control panel can
arm multiple partitions.
Outputs A menu option that sets a user's rights to
control the control panel's auxiliary out-
puts. These outputs must be pro-
grammed by the installer.
Problem zone A zone that prevents the system being
armed. A problem zone typically has an
open window or door (open zone) or a
tamper has occured on the zone (tamper
zone).
Reports Open/Close A menu option that sets the code of the
selected user to report arms (close) and
disarms (open).
Glossary
Sensor
Single-partition mode
Tamper
Up/download
User Authority
User code
Wireless zone
Zone
A device that detects violations and re-
ports them to the control panel. Sensors
include door and window contacts or any
device used to inform the control panel of
a particular condition.
The mode in which a control panel can
arm one partition only.
Interference with the system such as an
open casing.
Management software that can read the
software system programming informa-
tion (upload) or modify or replace the sys-
tem information if necessary (download).
A menu option that displays user rights.
A four or six digit code used to arm or dis-
arm the system and access the User
menu.
A sensor that transmits to the control pan-
el via a radio receiver rather than being
directly wired to the control panel.
An partition guarded by a group of one or
more detection devices.
NX-10 User Manual 35