Sanyo SHA TM64 AGB Instruction Manual page 7

Schedule Timer
STEP 3 Set up the program and press the SET button.
Select timer operation with the
and
ton. Then, set the trigger time with the HH and MM buttons, and
press the SET button.
When the SET button is pressed, the time set in program
changes from blinking to lighting and, at the same time, the time
set in program
NOTE
Every time the
changes in the order of
Every time the
indication changes in the order of
indication.
The remote control operation enable/disable setting is disabled
depending on installation conditions. In this case, only timer ON/
OFF can be set.
STEP 4 Set up programs
When the SET button is pressed, settings are automatically ar-
ranged in the order of earliest time fi rst.
If the SET button is pressed without any new settings being
made in the program, program
3
tings can be changed.
Similarly, if the SET button is pressed after setting up program
, program
STEP 5 Press the PROGRAM button.
Program settings are entered and the normal display returns.
STEP 6 Set up programmed operation for other groups and days of the week in the same way.
Programs that have already been set up can be copied into other groups and days of the week. (Refer to page
3-93.)
NOTE
A "0:00" time setting is interpreted to mean 12:00 midnight.
To cancel program settings during program setup (while "PG-1" or "PG-2" is blinking on the display),
hold down the CANCEL button for more than 2 seconds. The normal display returns.
If settings are canceled without pressing the PROGRAM button, settings are not entered.
(timer ON/ OFF) button
(remote controller operation enable/disable) but-
starts blinking.
button is pressed, the timer indication
(ON) (OFF) no indication.
button is pressed, the remote controller
(enabled)
~
in the same way.
starts blinking again and set-
starts blinking again.
.
(disabled) no