Toshiba RAV-SM404MUT-E Service Manual page 35

No. Item
13 Frequency <In case of wired remote controller>
fixed operation
1) When pushing [CHK] button for 4 seconds or more, [TEST] is
(Test run)
2) Push [ON/OFF] button.
3) Using [MODE] button, set the mode to [COOL] or [HEAT].
4) After the test run, push [ON/OFF] button to stop the operation.
5) Push [CHK] button to clear the test run mode.
<In case of wireless remote controller>
1) Turn off power of the set.
2) The test operation starts by [START/STOP] button.
3) Carry out a test operation under anyone mode of HEAT,
4) After the test operation, stop the unit by the wireless remote
Outline of specifications
displayed on the display screen and the mode enters in Test
run mode.
• Do not use other mode than [COOL]/[HEAT] mode.
• During test run operation, the temperature cannot be ad-
justed.
• An error is detected as usual.
• A frequency fixed operation is performed.
(Display in the display part is same as the procedure in Item 1.)
([TEST] display in the display part disappears and the status
returns to the normal stop status.)
(Compact 4-way, Concealed Duct type)
Remove the nameplate of the receiver unit and then turn the
Dip switch to [Test operation / ON].
• [START], [TIMER] and [READY] LEDs flash during test
operation
• Under condition of [Test operation / ON], the temperature
adjustment is invalid even if using the wireless remote
controller. Do not use it at other cases than a test operation
because it applies excessive force.
COOL or FAN operation mode.
• The outdoor unit does not operate for approx. 3 minutes
after the power supply was turned on and after operation
stop.
controller and then return Dip switch of the receiver unit to
the original position.
(In order to prevent sequential test operation, this receiving
unit is attached with 60-minutes timer release function.)
Receiver unit
M4 × 25 screw
(2 pieces)
Nameplate
Notch
Small screw
Spacer
– 35 –
Remarks
Command frequency is
approximately [S7]