Panasonic KX-NCP500 Manual page 56

4.4.1 Assigning the IP Addressing Information
4.
Not using a DHCP server when the IP-PT is on the remote office LAN
All the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.4.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
Select "Network".
IP Address*
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address
Select "Default Gateway".
To enter the IP address of the IPCMPR card (PBX IP Address)
Return to the
Menu screen.
ENTER
Continued on next page
56 IP Networking Guide
SETUP
Press "SETUP" when it is displayed.
ENTER Select "Disable"
for DHCP setting.
1
ENTER
Subnet Mask Address*
ENTER
Default Gateway Address*
ENTER
Software version 2.00 or later only
Select "PBX". ENTER
PBX IP Address
Select "IP Address".
2
3
Select "PBX IP ENTER
Address".
ENTER
ENTER
ENTER
ENTER
Select "Primary
PBX".
Document Version 2009-12