Sophos UTM. The wireless controller itself centrally manages all wireless access points; all you need to do is plug in the device anywhere in your network. The access point will find the controller, fetch its configuration and become operable within seconds.
Page 3
UTM appliance. For this to happen, the UTM appliance needs to be put in the upstream of the access points, either being the default gateway of the access points (which was provided by the DHCP service) or on the default route (most likely your route to the Internet).
Page 4
“Pending” on the Wireless Protection > Access Points tab in WebAdmin. The ID of the Access Points, shown in square brackets, is also printed on the bottom of the device. It can be used to distinguish the access point. By clicking the Accept button, you are given the option to select the channel this access point will transmit on.
Power supply Detachable dipole antenna Ethernet cable Mounting instructions The Sophos AP 10 can be mounted on the wall. Screws are not included in delivery. Only use screws whose dimensions correspond with the mounting holes on the back side. Controls...
EN 301489-1, EN CFR 47, Part 15 V-3/2011.04 301489-17 Subpart B V-4/2010.04 EMF: EN 50385 FCC 1.1310, IEEE C95.1 Safety: EN 60950-1 AP 10 Mounting template Do not shrink to fit when printing 8,85 cm (3,48 in) Wireless Access Points...
Page 7
2 screws and dowels Ethernet cable Important note: Sophos AP15 requires Sophos UTM V 9.207 to be installed. Mounting instructions The Sophos AP 15 can be mounted on the wall. Screws are included in delivery. Controls Green - blinking slowly AP is booting...
Page 8
WPA/WPA2, WEP, 802.1X (RADIUS) Number of supported SSIDs Regulatory compliance Radio: EN 300328 CFR 47, Part 15 Subpart C EMC: EN 301489-1, EN 301489-17 CFR 47, Part 15 Subpart B EMF: EN 50385 FCC 1.1310, IEEE C95.1 Safety: EN 60950-1 Wireless Access Points...
Page 9
Operating Instructions AP 15 Mounting template Do not shrink to fit when printing Wireless Access Points...
Page 10
+ power cord Mounting instructions The Sophos AP 30 can be mounted on the ceiling. Screws are included in delivery. Use the screws from the scope of supply or screws whose dimensions correspond with the mounting holes in the bracket.
Page 11
Radio: EN 300328 CFR 47, Part 15 Certification ID: Subpart C 201 WW 11215238 EMC: EN 301489-1, EN CFR 47, Part 15 V-3/2011.04 301489-17 Subpart B V-4/2010.04 EMF: EN 50385 FCC 1.1310, IEEE C95.1 Safety: EN 60950-1 Wireless Access Points...
Page 12
Ethernet cable injector + power cord Mounting instructions The Sophos AP 50 can be mounted on the wall. Screws are not included in delivery. Only use screws whose dimensions correspond with the mounting holes on the back side. AP 50...
Page 13
V-3/2013.04 EN 301489-17 V-4/2012.04 EN 60601-1-2 (medical electrical equipment) EMF: EN 50385 FCC 1.1310, IEEE C95.1 Safety: EN 60950-1 * It is recommended to only use PoE+ capable (IEEE 802.3at) equipment to power the Sophos AP 50. Wireless Access Points...
Page 14
Operating Instructions AP 50 Mounting template Do not shrink to fit when printing Wireless Access Points...
Page 15
Important note: Sophos AP 100 requires Sophos UTM V 9.207 to be installed. Mounting instructions The Sophos AP 100 can be mounted on the wall. A mounting kit is included in delivery. Controls Green - blinking slowly...
Page 16
Radio: EN 300 328, EN 301 893 CFR 47, Part 15 Subpart C, E EMC: EN 301 489-1, EN 301 489-17 CFR 47, Part 15 Subpart B EMF: EN 50385 FCC 1.1310, IEEE C95.1 Safety: EN 60950-1 Wireless Access Points...
Page 17
(Optionally included with AP 30,AP 50, and AP 100) The PoE injector converts alternating current (AC) to direct current (DC), which is then provided over the Ethernet cable to power the Sophos Access Points AP 30,AP 50, and AP 100.
Page 18
Registered in England and Wales No. 2096520, The Pentagon, Abingdon Science Park, Abingdon, OX14 3YP, UK Sophos is the registered trademark of Sophos Ltd. All other product and company names mentioned are trademarks or registered trademarks of their respective owners.
Need help?
Do you have a question about the Access Points and is the answer not in the manual?
Questions and answers