Hitachi N 5008AC Technical And Service Manual page 26

10-4. Disassembly and Reassembly of the Driving Section and the Magazine Section
(1) Nose [25], Pushing Lever [31] and the magazine section (See Fig. 16.)
Tool required
Hexagon bar wrench (4 mm)
Roll pin puller (3 mm (.118) dia., 5 mm (.197") dia.)
Flat-blade screwdriver
(a) Disassembly
Perform disassembly according to 10-2-(3) to remove the Nose [25], Pushing Lever [31], and the magazine
section.
Pull the Staple Feeder [63] of the magazine backward so that staples can be loaded.
Pull out the Pin [59] using the roll pin puller (5 mm (.197 ") dia.). Pull the magazine section from the tail
cover and gently put the staple feeder back as it was being careful not to lose the Shaft Ring [64].
Push out the Hinge Pin [67] with a flat-blade screwdriver as shown in Fig. 17. Holding the top of the
Cover Spring [58] with fingers, pull out the Hinge Pin [67]. Then the Magazine Ass'y [68] and the Magazine
Cover [57] can be removed.
Pull out the Roll Pin D3 x 6 [70] using the roll pin puller (3 mm (.118 ") dia.). Then the Magazine Piece [66]
can be removed.
Nose [25]
Magazine Cover [57]
Pin [59]
Shaft
Ring [64]
Staple Feeder [63]
Ribbon Spring [65]
Magazine Ass'y [68]
Hinge Pin [67]
Fig. 16
--- 23 ---
Magazine Piece [66]
Cover
Spring
[58]
Roll Pin D3 x 6 [70]