Door Switch - Whirlpool Duet Sport WFW8300SW Instruction Manual
Duet sport front loading
Hide thumbs
Also See for Duet Sport WFW8300SW:
- Use and care manual (52 pages) ,
- User manual (96 pages)
Table of Contents
Advertisement
Disconnect power before accessing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
DOOR SWITCH
Door Switch
Door Lock/
Unlock
Solenoids
Refer to page 4-14 for the procedure for ac-
cessing the door switch.
To check the door switch at the CCU, perform
the following steps.
1.
Unplug washer or disconnect power.
2.
Disconnect the door lock/unlock sole-
noids connector DL3 (see page 4-5) from
the CCU.
Electrical Shock Hazard
3.
Set the ohmmeter to the R X 1 scale.
4.
To test the door lock/unlock sole-
noids, touch the ohmmeter test leads to
the indicated pins on connector DL3. The
meter should indicate as follows:
Door Unlock Solenoid - Pins 2 & 3 = 60 Ω
Door Lock Solenoid - Pins 1 & 3 = 60 Ω
5.
Disconnect the door switch connector
DS2 (see page 4-5) from the CCU.
6.
To test the door switch, touch the ohm-
meter test leads to pins 3 and 1 at DS2.
The meter should indicate as follows:
Door Closed = 0 Ω
Door Open = infinite
1
2
3
Unlock Sol.
Connector DL3
At CCU
5-5
1
2
3
1
2
Door Sw.
Lock Sol.
Connector DS2
At CCU
3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Duet Sport WFW8300SW and is the answer not in the manual?
Questions and answers
le moteur ou pompe semble mort l'eau ne se vide plus. Quel est le problème elle ne fonctionne plus.
If the washer's motor or pump seems dead and water is not draining, possible issues include:
1. Drain hose may be plugged or kinked.
2. Drain pump filter may be clogged with foreign objects.
3. Drain pump may have failed.
4. Wiring connections to the drain pump, pressure switch, water inlet valve, or Central Control Unit (CCU) may be loose or faulty.
5. There may be a communication error between the CCU and the Motor Control Unit (MCU).
6. The MCU may not be operating or the drive motor is not receiving power.
Steps to diagnose:
- Unplug washer and check hose, pump filter, and wiring connections.
- Plug in washer and check for drive motor or MCU operation.
- Run a diagnostic test to verify CCU function.
This answer is automatically generated