Removing The Drain Pump - Whirlpool Duet Sport WFW8300SW Instruction Manual
Duet sport front loading
Hide thumbs
Also See for Duet Sport WFW8300SW:
- Use and care manual (52 pages) ,
- User manual (96 pages)
Table of Contents
Advertisement
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer.
3.
Remove the lower front access panel (see
step 10 on page 4-11 for the procedure).
4.
Using a shallow pan to catch the water,
unscrew the filter from the drain pump,
and drain the water from the pump.
Drain Pump Filter
REMOVING THE DRAIN PUMP
Drain Pump
5.
Loosen the clamp and remove the pump-
to-tub hose from the drain pump.
6.
Loosen the clamp and remove the pump-
to-drain hose from the drain pump.
REASSEMBLY NOTE: When you reconnect
the hoses, align their tab(s) with the marks on
the drain pump.
Pump-To-Tub Hose
Tab
Arrow
7.
Using a flat-blade screwdriver, lift the
rubber pad, and slide the pump to the left
and unhook the bottom tab, then lift the
pump out of the chassis floor slots.
Continued on the next page.
4-17
Pump-To-
Drain Hose
Tabs
Lift Rubber Pad
Tab
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Duet Sport WFW8300SW and is the answer not in the manual?
Questions and answers
le moteur ou pompe semble mort l'eau ne se vide plus. Quel est le problème elle ne fonctionne plus.
If the washer's motor or pump seems dead and water is not draining, possible issues include:
1. Drain hose may be plugged or kinked.
2. Drain pump filter may be clogged with foreign objects.
3. Drain pump may have failed.
4. Wiring connections to the drain pump, pressure switch, water inlet valve, or Central Control Unit (CCU) may be loose or faulty.
5. There may be a communication error between the CCU and the Motor Control Unit (MCU).
6. The MCU may not be operating or the drive motor is not receiving power.
Steps to diagnose:
- Unplug washer and check hose, pump filter, and wiring connections.
- Plug in washer and check for drive motor or MCU operation.
- Run a diagnostic test to verify CCU function.
This answer is automatically generated