SAFETY PRECAUTIONS This service information is intended iar with proper and safe procedures All tests and repairs should be performed with proper tools and measuring service technician using only Maytag Improper assembly or adjustment other than qualified service technicians pany replacement parts are used.
Each section is further subdivided to describe a are added or new models are introduced. pages as they are used. COVERED IN THIS MANUAL: WM27260 WM27460 WM30460 JJW8527 JJW8530 JJW8627 JJW8630 JJW9527 JJW9530 JJW9627 JJW9630 JMW8527 JMW8530 JMW9527 JMW9530 01999 Maytag Appliances Sales Company the filing...
Allows the electronic control to maintain a temperature resistance matching with the control-se- lected temperature. control is set at 350°F, the oven sensor offsets. It is resistance at room temperature mately 1060 ohms. _1999 Maytag Appliances Sales Company...
Check control. If keyboard is not disconnected (F1-4) or key is not shorted (F1-3), replace control. Ohm sensor. See chart, Check Latch Assembly (Oven Sensor Chart: Please refer to chart on 1-3) O199g Maytag Appliances Sales Company OVEN SENSOR Calibration:...
Page 9
165.2 7456 210.1 3886 For Models: W27400, W30400, W30400RWW27430, WM30460, JJW8527, JJW85300 JJW86270 JJW8630, JJW9527, JMW8527, JMW8530, JMW9527, 16009721 COMPONENTS J1, J2 wire harness connection to control shorted. If control. checks ok, change Ohm TEST SENSOR. If checks Ohm sensor.
Page 10
TO ELEMENT DURING TIME OF DAY DISPLAY. Over temperature sensed by control bake mode, or over 950 sensed mode. Cooling fan on with no oven function selected, Shorted oven sensor Power element relays mode. Shorted key sensed Shorted meat probe...
PhiLlips screw- driver. the lock plate from each side, Raise the oven door up to a broil stop position. against the 1/8" pin. Grasp the door toward the top on both sides. Lift the door up and out to re- move.
Oven Sensor Removal Remove two 1/4" hex screws, pull oven sensor into oven cavity to gain access to the electrical quick connector. To reassemble, use a probe and attach the probe to the quick connector, through the insulation tor does not contact the oven cavity.
Bulb can be replaced or accessed by turning the lens counterclockwise to remove the entire oven light. The socket can be removed by depressing the spring clips from the rear of the light socket end pushing it into the oven cavity.
If there is a red dot on the IC-chip and the display board when you touch the oven light key, the oven light will come on and a beep will occur. The beep is to let you know that there is a good circuit, in case the light is blown.
Page 16
"F" or "C." The display can be toggled by pushing the bake or upper bake key to toggle the clock. The temperature the broil key or upper broil key on a double oven control. 16009721 digits.
Page 17
User Selectable Display Code Display Code 16009721 Options Display Codes 24 Hour Continuous Deg. C Clock Door Lock Switch Codes Unlocked Locked Switch Switch closed closed open closed closed open open open closed closed open closed closed open open open @1999 Maytag Appliances Sales Company 60 Hz Reference...
Page 18
Over temperature sensed by control in time of day mode, bake mode, or over 950 ° sensed in clean mode. Cooling fan on with no oven function selected. Shorted oven sensor Power to element relays disabled in cook mode.
POWER RELAY BOARD CONNECTIONS TO L1 NEU'm_ OVEN UGHT "--_OVLT n.-.. UNIT BROIL :..i BAKE BAKE UNIT 16009721 01999 DISPLAy BOARD DOOR NCor-- USED USED DRLK _]_ COOL CVRST []_ CVBAK _ TO L2 CONVECTION MOTOR SLOW SPEED Maytag Appliances Sales Company...
MEMBRANE CONNECTIONS LO BAKE LO BROIL LO CLEAN TIMER ONE STOP TIME CLOCK PROBE OVEN LIGHT TIMER TWO COOK TIM E UPPER BAKE UPPER BROIL UPPER CLEAN UPPER CONVECTION BAKE UPPER CONVECTION ROAST UPPER CANCEL LOWER CANCEL Membrane Switch: The means to make a...
Page 26
OOOR BOARD LOCI< CVBAK •_ TO L2 CONVECTION MOTOR SLOW SPEED O1999 Mayteg Appliances Sales Company LOWER DOOR LOCK IpRTOB JACK | LOWER OVEN .J SENSOR "m--_IuPPER OVEN ]SENSER DITOsPLAY JBOARD TOuxILLARy RELAY BOARD UPPER DOOR DRLK _-- LOCK MOTOR...
Page 27
AUXILLARY RELAY BOARD-DOUBLE TO L1 NEUTRAL To D LOWER DOOR LOCK MOTOR DRLK LOWER BAKE UNIT 16009721 WALL OVEN BROIL T.° OWER BROIL UNIT TO L2 01999 Maytag Appliances Sales Company RELAY BOARD SC11TrlF TROUBLESHOOTING 3-13...
Page 28
BROIL-- UNIT CVBAKI CWSTIR L.TO UPPER BAKE UNIT CONVECTION MOTOR SLOW SPEED 8C111rNF 16009721 WALL OVEN MOTOR Oo.N G TO NEUTRAL _ TO LOWER DOOR LOCK MOTOR CONVECTION MOTOR HIGH SPEED @1999 Msytag Appliances Sales Company DRLK LOWER BAKE "91...
Page 29
ELECTRONIC CONTROL PROGRAMMABLE TEMPERATURE OFFSET CHANGE: Program bake above 500 degrees F Repress bake pad and hold for 3 to 4 seconds The digital keys can be used to offset between 0 to 35 degrees in increments of 5 degrees. The broil key is used to toggle between positive and negative offsets.
Page 30
Convect Roast Pad-Press the pad in the test mode and the convect roast relay will be activated. Oven Light Pad- Press the pad in the test mode and the oven light relay will be activated. Probe Pad- Press the probe pad in the test mode and the probe temperature be displayed.
Page 31
USER SELECt'ABLE OPTION DISPLAY CODES DISPLAY DEG C CODE J1, J2 wire harness connection co ntro I shorted, checks ok, change control. 16009721 €1999 Maytag Appliances Sales Company CONTINUOUS 24 HR CLOCK 60 HZ REFERENCE × TROUBLESHOOTING 3-17...
Page 32
DOOR LOCK SWITCH CODES UNLOCKED DISPLAY CODES SWITCH CLOSED OPEN CLOSED OPEN CLOSED OPEN CLOSED OPEN For JJW Models To test the control the following Bake Pad- Touch the bake pad then touch the auto set pad within 4 seconds of each other.
Need help?
Do you have a question about the JJW8630 and is the answer not in the manual?
Questions and answers
what amp. breaker for model W30400P conv. oven