Table of Contents
Advertisement
I I r r o o n n & & O O a a k k
2 2 0 0 , , 2 2 2 2 , , a a n n d d 2 2 6 6 T T o o n n
Vertical / Horizontal Log Splitters
Standard & DURO-GLIDE Models
M M o o d d e e l l s s : : B B H H V V H H 2 2 2 2 0 0 2 2
B B H H V V H H 2 2 2 2 0 0 2 2 F F C C
B B H H V V H H 2 2 6 6 0 0 2 2
Owner / Operator
and Safety Manual
Advertisement
Table of Contents
Related Manuals for Iron & Oak BHVH2202
Summary of Contents for Iron & Oak BHVH2202
- Page 1 I I r r o o n n & & O O a a k k 2 2 0 0 , , 2 2 2 2 , , a a n n d d 2 2 6 6 T T o o n n Vertical / Horizontal Log Splitters Standard &...
- Page 2 Initial Start-Up Instructions ❏ ❏ Read all assembly, operating, and safety instructions. ❏ ❏ Complete and return the warranty card to register your log split- ter. ❏ ❏ Write the serial number and date-of-purchase in this manual. ❏ ❏ Assemble the log splitter. ❏...
-
Page 3: Table Of Contents
Contents WARNING Introduction ............4 To avoid personal injury or death, carefully read and understand all Safety. -
Page 4: Introduction
Splitters are designed for tough applications in both vertical and horizontal positions. ter safely. With 22 tons (model BHVH2202) or 26 tons (model BHVH2602) of splitting force, a 12 Personal Protection second cycle time, and a 5 HP or an 8 HP engine either model will handle most of your ✔... -
Page 5: Operating Safety
Safety Safety ✘ Operating Safety Only use your hand to operate the control lever. NEVER use your foot, knee, a rope, or any other extension device. ✔ ALLOW ONLY ONE (1) PERSON TO LOAD AND OPERATE THE LOG SPLITTER. Log Splitting Safety ✔... -
Page 6: Towing
Safety Safety Towing ✔ Always store gasoline in an approved, tightly sealed container. Store the con- tainer in a cool, dry place. Do not store the container in a house or near any ✔ ALWAYS check before towing to make certain your log splitter is correctly and heating appliance. -
Page 7: Assembly Instructions
If the parts are damaged call Iron & Oak Products at The following chart contains the list of parts that should be shipped as part of the (815) 672-8596. BHVH2202, BHVH2202FC, or BHVH2602 Log Splitter. Description Description Base Unit (engine) -
Page 8: Assembly Procedure
Assembly Instructions Assembly Instructions Assembly Procedure 3. Carefully stand the rail assembly in an upright, vertical position. CAUTION Some components are very heavy WARNING and can be damaged if mishan- Make sure the rail assembly is standing on dled. Also, to help prevent per- a flat, level area. - Page 9 Assembly Instructions Assembly Instructions 6. Bolt the rail rest to the rail assembly using 10. Install the valve link onto the valve body, two 1/2-13 x 1-1/2 inch long hex head as shown, using a 1/4 x 1 inch long clevis bolts, lockwashers, and nuts, as shown.
-
Page 10: Start-Up Procedure
Assembly Instructions Start-Up Procedure Important Notice 14. Coat the threads of the fitting with a Do not start the engine. Follow all of the instructions in the “Start-up Pro- hydraulic pipe sealant and attach the cedure” before operating the log splitter. Failure to follow this recommen- high-pressure hose from the bottom dation will result in engine and hydraulic pump damage. -
Page 11: Towing
Start-Up Procedure Towing 6. Check the fluid level in the hydraulic tank and add oil as needed. WARNING WARNING Maximum Speed Limit — 35 mph Your log splitter is built on a solid, unsuspended axle. To prevent damage or Be careful not to spill fuel when filling the engine. If fuel should spill, possible loss of vehicle control, use extreme caution when towing and do not quickly wipe off and allow the excess fuel to evaporate before continu- exceed a vehicle speed of 35 mph, especially when driving on a bumpy road. -
Page 12: Operation
Operation Towing WARNING 4. Place a customer supplied lock or lock pin into the latch assembly of the hitch cou- Do not attempt to operate the log splitter without fully understanding pler. all our instructions, safety precautions, and/or warnings. If any doubt or question arises about the correct or safe method of performing any- WARNING thing found in this or other Iron &... -
Page 13: Operation - Horizontal Position
Operation Operation 3. Start the engine using the instructions from b. Only using your hand, push the control the engine manual. If the log splitter has lever forward (towards the log). If the not been running (cold engine), warm up log moves, before it is contacted by the engine and hydraulic system by run- the splitting wedge, release the control... -
Page 14: Operation - Vertical Position
Operation Operation Operation – Vertical Position c. Hold the control lever, extending the splitting wedge, until the log is split or WARNING the cylinder rod stops at its maximum travel position. Stop the log splitter Before loading and operating the log splitter, (forward movement), at any point in always wear protective gear, such as safety the splitting process, if you feel an... - Page 15 Operation Operation d. Move the log under the splitting wedge f. Hold the control lever, extending the keeping your hands on the sides of the splitting wedge, until the log is split or log near the middle of the block. Cen- the cylinder rod stops at its maximum ter the log making sure that the sawed travel position.
-
Page 16: Inspection And Maintenance
Inspection and Maintenance Inspection and Maintenance General Maintenance Check (before operating) Hydraulic Oil Change The hydraulic system (hoses, cylinder, and pump) should be carefully inspected before Iron & Oak Commercial Products recommends an oil and filter change every 100 hours each use. -
Page 17: Specifications
4. Refill the hydraulic tank. Mechanical Specifications (Model BHVH2202) Beam ......6 x 6 inch reinforced, heavy-duty H-beam a. -
Page 18: Hydraulic Specifications
Troubleshooting Specifications Hydraulic Specifications (Model BHVH2202) The following section will detail procedures for checking your log splitter, should you encounter a malfunction. We recommend that you do not attempt to make repairs to the Cylinder Size ....4 x 24 inch, clevis type cylinder with 1 3/4 inch rod log splitter. -
Page 19: Decals
Decals Decals WARNING Make sure all decals are attached to the log splitter and/or engine and are legible at all times. Item Part No. Description Qty. BR002652 Decal, Notice BR002665 Decal, Warning Engine 3 (NS) BR002627 Decal, Iron & Oak (2202) BR002627 Decal, Iron &... -
Page 20: Parts
Parts Parts Iron & Oak 815-672-8596 815-672-8596 Iron & Oak... - Page 21 Parts Parts Standard Rail Iron & Oak 815-672-8596 815-672-8596 Iron & Oak...
- Page 22 Parts Parts DURO-GLIDE Rail Iron & Oak 815-672-8596 815-672-8596 Iron & Oak...
- Page 23 Parts Parts Iron & Oak 815-672-8596 815-672-8596 Iron & Oak...
-
Page 24: Warranty
Warranty For one year from the date of purchase, Iron & Oak Commercial Products, Inc. will replace for the original purchaser, or repair free of charge, all parts of the Iron & Oak Commercial Products hydraulic log splitter, returned to our factory PREPAID and found upon inspection by us to be faulty, due to defects in materials or workmanship. -
Page 25: Optional Attachments
Optional Attachments Log Cradle (Part No. BR021180) ✔ Holds log in place on top of rail for faster splitting. ✔ Catches split logs - no more stooping to pick up the split pieces. ✔ Each shelf is infinitely adjustable up to 45 degrees to accommodate various sizes of logs. -
Page 26: Safety Flag Kit
Optional Attachments Safety Flag Kit (Part No. BR012104) ✔ Improves visibility of log splitter when backing up or tow- ing. ✔ Heavy-duty tapered fiberglass pole won't bend over at towing speeds. ✔ Installs in minutes, no drilling required. ✔ Mounting instructions included. Iron &... - Page 27 Iron & Oak Commercial Products, Inc. 410 W. Broadway Ave. Streator, Illinois 61364-0577 Phone: 815-672-8596 Fax: 815-672-9073 E-mail: sales@logsplitters-ironoak.com Web Site: www.logsplitters-ironoak.com BHVH2202/2202FC/2602-01 02/04...
Need help?
Do you have a question about the BHVH2202 and is the answer not in the manual?
Questions and answers