Mounting the handle shaft and handle (A)
Push the Holder [88] in the Back Cover [76] by hand. At this time, check that the clearance of the Holder [88]
does not protrude from the main body and the Holder [88] does not protrude from the end surface of the Back
Cover [76]. Check that the convex mark of the Back Cover [76] aligns with the convex mark of the Handle
Shaft [87]. Then mount the Handle Shaft [87] and push the four Handle Dampers [86] in the clearances
between the Holder [88] and the Handle Shaft [87] by hand being careful not to protrude the Handle Dampers
[86] from the end surface of the Back Cover [76] (Fig. 24).
Convex mark
Holder
Holder damper
Handle shaft
Clearance
Fig. 24
To mount Handle (A).(B) Set [81], turn the Handle Shaft [87] by about 10û and fit the Transatory Unit [90] and
the Handle Shaft [87] in Handle (A).(B) Set [81] together.
--- 23 ---