Fault code No.
14
Used diagnostic code No. D03 (intake air pressure sensor)
Inspection operation item and
Order
probable cause
1
1
Connected state of connector
Intake air pressure sensor cou-
pler
Main wirring harness ECU cou-
pler
Sub-wire harness coupler
2
2
Defective intake air pressure
sensor.
Fault code No.
15
Used diagnostic code No. D01 (throttle position sensor)
Inspection operation item and
Order
probable cause
1
1
1
1
Installed condition of throttle
position sensor.
2
2
2
2
Connected condition of con-
nector
Inspect the coupler for any
pins that may have pulled
out.
Check the locking condition
of the coupler.
3
3
3
3
Open or short circuit in wiring
harness and/or sub lead.
4
4
4
4
Defective throttle position sen-
sor.
FUEL INJECTION SYSTEM
Intake air pressure sensor-hose system malfunction
Symptom
Operation item and countermeasure
Check the coupler for any pins that may have
pulled out.
Check that the coupler is connected securely.
If there is a malfunction, repair it and connect
it securely.
Execute the diagnostic mode (code No. D03)
Replace the throttle body.
NOTE:
Do not remove the sensor assembly (MAQS).
Refer to "Fault code No. 13".
Symptom
Throttle position sensor-open or short circuit detected.
Operation item and countermeasure
Check the installed area for looseness or
pinching.
Check that it is installed in the specified po-
sition.
Refer to "THROTTLE BODY AND FUEL IN-
JECTOR".
If there is a malfunction, repair it and connect
it securely.
Throttle position sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
black/blue - black/blue
yellow - yellow
blue -blue
Execute the diagnostic mode (code No. D01)
Replace the throttle body.
NOTE:
Do not remove the sensor assembly (MAQS).
Refer to "THROTTLE BODY AND FUEL IN-
JECTOR ".
(clogged or detached hose).
tached hose).
7-15
FI
ifl
Reinstatement
method
Reinstated by start-
Reinstated by start-
ing the engine and
ing the engine and
operating it at idle.
operating it at idle.
Reinstatement
method
Reinstated by turn-
Reinstated by turn-
Reinstated by turn-
Reinstated by turn-
ing the main switch
ing the main switch
ing the main switch
ing the main switch
ON.
ON.
ON.
ON.