Trouble Shooting - Daewoo DWD-M1031 Instruction Manual

TROUBLE SHOOTING

Most problems are easily solved if you understand the cause.
Check the following list for problem before calling for service.
Problem
Program dose not start. Plug is loose or not plugged in.
Power failure.
Loading door is not closed.
Program is not selected.
Start/hold button is not pressed.
Water dose not enter
Water tap is not turned on.
the washing machine.
Inlet hose is kinked or folded.
Filters is blocked in water inlet
filter.
Washing machine is Drain hose is kinked or clogged.
not drain.
Pump filter is clogged.
Washing machine is The amount of laundry is too
not spin. small.
The laundry is unbalanced.
Spin result is Drain hose is placed over 1m
unsatisfactory. above the floor.
Foam come out of the Too much detergent or unsuitable
detergent case. detergent used.
Serious noise and Transit bolts are not removed.
vibration
Washing machine is installed on
uneven floor.
Washing machine is not leveled.
DISPLAY ERROR MESSAGE
MESSAGE ERROR
WATER
IE INLET
ERROR
DRAIN
OE
ERROR
UNBALANCE
UE
ERROR
DOOR
LE
OPEN
ERROR
Cause
CAUSE
The water tap is closed.
The filter of the valve inlet is clogged.
The valve inlet is an inferior product or broke
down.
The water level sensor (sensor pressure) is an
inferior product or broke down.
The drain motor works during water supply.
The PCB ASS'Y does not check the water level.
The drain hose is kinked or clogged.
The drain motor is an inferior product.
The valve inlet works during drain.
The water level sensor is an inferior product.
The PCB ASS'Y does not check the water level.
The laundry is concentrated to one side of the
drum during spin.
The Start/Hold button is pressed while the door is
opened.
The switch door lock is an inferior product.
The PCB ASS'Y does not check the door lock.
15
Solution
Insert plug tightly.
An interrupted program will be resumed when the
power return.
Check whether laundry is trapped in door.
Close the loading door. (a click should be heard)
Select the desired program.
Press the Start/hold button.
Turn the water tap on.
Straighten the inlet hose.
Clean the water inlet filter.
Straighten and clean the drain hose.
Clean the pump filter
Add the laundry to balance. And repeat the Spin
cycle.
Rearrange the laundry. And repeat the Spin cycle.
If articles of heavy clothing (e.g. bath robe) are
loaded, washing machine may skip or stop the spin
cycle.
Place the drain hose under 1m above the floor.
Repeat the Rinse cycle.
Remove the transit bolts
Reinstall washing machine on even floor.
Adjust the level of washing machine using adjustable
legs.
SOLUTION
Open the water tap.
Clean the filter of the valve inlet.
Change the valve inlet.
Change the water level sensor
(sensor pressure).
Change the drain motor.
Change the PCB ASS'Y.
Clean and straighten the drain hose.
Change the drain motor.
Change the valve inlet
Change the water level sensor.
Change the PCB ASS'Y.
Rearrange the laundry.
Close the door.
Change the switch door lock.
Change the PCB ASS'Y.