Defender LL6070 Owner's Manual page 10

(C) Activation switch is not initially in ON position
(D) Monitor is activated when switch is in ON position
If the activation switch is not set to ON position, as in diagram (D), the mounting hole at
top of monitor will be blocked, and the CO monitor will not be activated.
The model LL6070 is a sealed lithium battery powered wall mounted Low Level CO
Monitor. Two lithium battery cells are permanently sealed with soldered connections,
and cannot be removed. No battery replacement is required, and the factory sealed
batteries should power the monitor for up to five years under normal operation.
Lift up Stop and
slide to left to
permanently deactivate
CO Monitor when
END-OF-LIFE signals
are initiated
Lift up Stop and
slide to left to
permanently deactivate
CO Monitor when
END-OF-LIFE signals
are initiated
Mounting hole is closed when
switch is in initial position
To activate CO Monitor,
ON
slide the monitor down
DEACTIVATE onto mounting plate, or
slide to Stop
Mounting hole is open when
switch is in ON position
To activate CO Monitor,
ON
slide the monitor down
DEACTIVATE
onto mounting plate, or
slide to Stop
- 10 -