Control Panel Fault Indicator Codes - Tennant T5 Operator's Manual

OPERATION

CONTROL PANEL FAULT INDICATOR CODES

The control panel fault indicator lights will display the following codes when the machine detects a fault.
CODE
Light #1 blinks
Lights #1, #2 and #3
ripple
Lights #1 and #4 blink
Lights #3 and #4 blink
Lights #2 and #3 blink
Lights #1 and #3 blink
Light #2 blinks
Lights #1 and #2 blink
Light #3 blinks
Light #3 blinks when
pressing the solution flow,
brush pressure buttons
and FaST system switch
Lights #1, #2 and #3 blink
All battery lights blink
All battery lights ripple
34
Light #4
Light #1 Light #2
FAULT
Recovery tank is raised.
Battery charger connected.
Left Brush motor overload.
Right Brush motor overload.
Propel motor overload.
Exceeded maximum incline.
Scrub head movement is obstructed or
actuator motor malfunction.
Vacuum motor malfunction.
Propel throttle malfunction.
FaST pump overload or malfunction.
Supervisor controls activated
(lockout feature)
Wand Pump overload or malfunction.
Emergency--Stop button activated
Key turned on while bail was engaged.
Light #3 Battery Lights
SOLUTION
Lower recovery tank. Restart key to reset.
Disconnect battery charger. Restart key to
reset.
Inspect brush for entangled debris,
improper pad or contact service center.
Restart key to reset.
Inspect brush for entangled debris,
improper pad or contact service center.
Restart key to reset.
Avoid steep inclines or contact service
center. Restart key to reset.
Check scrub head for obstruction or con-
tact service center. Restart key to reset.
Contact service center.
Contact service center.
Reset the 10A circuit breaker or contact
service center. Restart key to reset.
Contact your Supervisor.
Reset the 10A circuit breaker button or
contact service center. Restart key to
reset.
Turn button clockwise to reset.
Release the control handle start bail.
Tennant T5 (06- -06)