Setting Up Your Remote To Control Other Devices (Tv/Dvd/Etc) - AT&T U-verse User Manual

Quick Setup Guide
NOTE: The USB Converter must be installed in the front USB port of the U-verse Receiver only.
It will not operate if installed in the USB ports on the back of the receiver.
NOTE: After installing the USB Converter, test the POWER, CHANNEL and VOLUME keys for proper
operation. If there is any problem, the USB Converter can be swiveled up or down for optimum
performance.

3. Setting up your Remote to control other devices (TV/DVD/etc)

To control other devices, your RF Remote Control needs to be programmed. For older devices,
the RF Remote Control contains the IR codes to control them. For newer models of devices
(less than 6 months old) it is likely that the RF Remote Control will have to "learn" the IR codes.
• If your device is older, start with Section 3A (Search for Device Codes).
If Method 1 doesn't work, use Section 3B (Learning Device Codes).
• If your device is newer (less than 6 months), then start with Section 3B (Learning Device
Codes).