Tunnel Mpls Traffic-Eng Class-Type; Tunnel Mpls Traffic-Eng Path-Option - Zte ZXR10 Command Manual

ZXR10 Command Manual (MPLS Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
98 Confidential and Proprietary Information of ZTE CORPORATION
tunnel mpls traffic-eng
class-type
Use this command to configure the tunnel class type and the band-
width requirement in tunnel interface configuration mode. Cancel
this configuration with the no form of this command.
Tunnel interface configuration
tunnel mpls traffic-eng class-type <ct>[bandwidth <bw>]
no tunnel mpls traffic-eng class-type <ct>
<ctr>
<bw>
The default type is CT0, and there is no bandwidth requirements
by default.
This command is supported after the platform version 4.8.20.
This example describes how to configure the CT type of the tunnel
as 1, and the bandwidth requirement as 1000kps.
ZXR10(config)#interface tunnel5
ZXR10(config-if)# tunnel mpls traffic-eng class-type 1
bandwidth 1000
tunnel mpls traffic-eng
path-option
Use this command to configure to obtain ERO by dynamic selection
or explicit path statically on tunnel interface of the device. Cancel
the setting with the no command.
Tunnel interface configuration
tunnel mpls traffic-eng path-option <number>{dynamic |
explicit {name <path-name>| identifier <id>}}
no tunnel mpls traffic-eng path-option <number>
<number>
name <path-name>
dynamic
identifier <id>
Class type, range: 0~1
Bandwidth requirement under the class type,
range: 1~10000000
Number of the option, range: 1~16
Name of the used explicit path, 1~16
characters
Uses the dynamic path computation mode
Digital identifier of the used explicit path,
range: 1~65535