Neighbor Route-Map - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
108 Confidential and Proprietary Information of ZTE CORPORATION
neighbor [<ipv4-address>|<ipv6-address>|<peer-group-nam
e>] remove-private-as
no neighbor [<ipv4-address>|<ipv6-address>|<peer-group-na
me>] remove-private-as
<ipv4-address>
<ipv6-address>
<peer-group-name>
This command is enabled by default, that is, the private AS number
will be filtered out.
Since the quantity of AS numbers is limited, the private AS number
can be used to divide a large AS into multiple areas connected by
EBGP. The private Ass will be filtered in the access to the Internet.
In this way, the inside is transparent for the Internet.
The range of the private AS is 64512~65535.
Tip:
When a confederation is configured, since the peers in the confed-
eration are mostly marked as "private as", it may cause the route
loopback if the private AS is removed. As a result, this command
is ineffective to the EBGP peers inside the confederation.
This example describes how to filter the private AS in routes ad-
vertised to the BGP neighbor 2000::1.
ZXR10(config)#router bgp 1
ZXR10(config-router)#address-family ipv6
ZXR10(config-router)#neighbor 2000::1 remove-private-as

neighbor route-map

Use this command to filter the routes advertised to/from neighbors
or neighbor peers or configure the priorities for routes. Delete the
filter policy with the no form of this command.
Router configuration and address family configuration
neighbor [<ipv4-address>|<ipv6-address>|<peer-group-nam
e>] route-map <map-tag>{in | out}
no neighbor [<ipv4-address>|<ipv6-address>|<peer-group-na
me>] route-map <map-tag>{in | out}
<ipv4-address>
<ipv6-address>
<peer-group-name>
Neighbor IPv4 address
Neighbor IPv6 address
Peer group name
Neighbor IPv4 address
Neighbor IPv6 address
Peer group name