Indicator Statuses In Normal Operation - Epson dreamio EH-R4000 User Manual

Lamp replacement warning
Orange
It is time to replace the lamp. Replace the lamp with a new one as soon as possible.
If you continue to use the projector without replacing the lamp, the lamp may blowout.

Indicator statuses in normal operation

During normal operation, the
Standby condition If you press
Warm-up in
progress
Projection in
progress
Cool-down
progress
(Approx. 16
seconds)
Preparing for
network
monitoring
(EH-R4000 only)
indicator is off.
L
, projection will start after a brief interval.
Warm-up time is approximately 50 seconds.
While the projector is warming up, you cannot press
A
control or on the projector's control panel to switch the projector
to standby mode.
Normal operation is in progress.
The indicator is off when the illumination function is set to "Off".
Remote control and control panel are disabled while cool-down is in
progress. Once cool-down is complete, the projector turns to stand-by
in
mode. If the main power switch at the rear of the projector is turned off
while cool-down is still in progress, wait until the lamp has cooled
down sufficiently (approximately 10 minutes is required), and then turn
the main power switch back on.
None of the buttons can be operated while this is flashing.
Problem Solving
p.70
: Lit : Flashing
M
on the remote
55