Infinova V5822IR-A3 SERIES User Manual page 9

Step 3: Adjust viewing angle
Check whether the cables are properly and firmly connected before powering
on. The dome camera will perform a self-test for about 30 seconds after
power-on. Then loosen the locking screw to adjust the camera angle according
to your surveillance need. The camera features X, Y, Z 3-axis adjustment. It
allows 0°~350° panning adjustment, 0°~75° tilting adjustment and -85°~85°
rotating adjustment.
Step 4: Set camera function
You can use the DIP switch in the upper housing to set the desired video
quality on site. The detailed instructions are specified in Chapter IV.
Step 5: Install dome bubble
Install the bubble flange to upper housing. In this process, the shielding cover
may block the camera. Thus, before securing the bubble, user should adjust the
shielding cover to a proper position. Then, fasten the screws.
With all the procedures finished, user should further confirm whether each part
.
of the device is properly and firmly connected
Figure 3-8
7