Cub Cadet 182 Operator's Manual page 10

2. Follow steps below to attach grass catcher:
a. Lift rear discharge door.
b. Remove rear mulching baffle.
c. Place grass catcher on the pivot rod. Let go of
discharge door so that it rests on the grass catcher.
See Fig. 3-6.
To remove grass catcher, lift rear discharge door on the mower.
Lift grass catcher up and out, off of the pivot rod. Release rear
discharge door to allow it to close rear opening of mower.
WARNING:
on the grass catcher are firmly seated on the pivot
rod and the rear discharge door rests firmly against
top of the grass catcher.
10 s 3 — a
ectiOn sseMbly
Figure 3-6
Never operate mower unless the hooks
& s -u
et p
Side Discharge Chute
To convert to side discharge, make sure grass catcher is off of
the unit, the rear mulching baffle is removed, and rear discharge
door is closed.
1. On the side of the mower, lift the mulching plug.
2. Slide chute hooks under hinge pin on mulching plug
assembly. Lower mulching plug. See Fig. 3-7. Do not
remove side mulching plug at any time, even when you are
not mulching.
Figure 3-7
Adjustments
1. The cutting height adjustment lever is located above the
rear left wheel. See Fig. 3-8.
a. Pull the lever out and away from the mower.
b. Move the lever forward or back for desired cutting
height.
c. Release lever towards mower deck.
Figure 3-8
1
2
B
A
C