Transferring A Call - Sony IPELA PCS-G70 Operating Instructions Manual

Notes
• Only "Disconnect" and "Resume Call" are available in the hold mode.
• Only "Disconnect" is available in the hold mode.
• When all the receiving terminals enter the hold mode in a multipoint videoconference
during transmission or reception of the data via the Data Solution Box or the White
Board, the transmission or reception is cancelled and will not be restored after the
hold mode is cancelled. If a connected terminal puts a call on hold but communication
with other terminal(s) remains established, however, transmission or reception via the
Data Solution Box or the White Board is not cancelled.

Transferring a Call

You can transfer a call to another remote party during a point-to-point
videoconference when connected by SIP.
Note
Call transfer is not possible during a multipoint videoconference.
1
Press the CONNECT/DISCONNECT (
Commander during communication.
The following menu appears.
2
Select "Transfer" using the V, v, B or b button and the PUSH ENTER
button on the Remote Commander.
The remote terminal in communication enters the hold mode. The hold mode
continues until the call transfer is completed.
Notes
• "Resume Call" is not available on the remote terminal in the hold mode. Only
"Disconnect" is available on that terminal.
• If you operate the system to transfer a call during transmission or reception of the
data via the Data Solution Box or the White Board, the transmission or reception
is cancelled and will not be restored after call transfer is completed.
246
Starting a Videoconference Using SIP
/ ) button on the Remote