Precautions In Disassembly And Reassembly; Disassembly - Hitachi C 10FM Technical Data And Service Manual

10. PRECAUTIONS IN DISASSEMBLY AND REASSEMBLY

Please follow the precautions below for disassembly and reassembly procedures. The circled numbers in the
following figures and the [Bold] numbers in the descriptions below correspond to the item numbers in the Parts
List and exploded assembly diagrams.
CAUTION: Prior to attempting disassembly or replacement of the saw blade, ensure that the power cord
plug is disconnected from the power source.

10-1. Disassembly

A. Disassembly of the blade guard section
Tools required:
• Phillips head screwdriver
• 12.7 mm wrench (standard accessory)
• 10 mm wrench
1. Loosen the Counter Hd. Screw M5 x 12 [25] and turn the Cutter Shaft Guard [26] upward so that the Bolt (Left
Hand) W/Washer M8 x 20 [51] can be seen.
2. Put the Wrench [702] on the Bolt (Left Hand) W/Washer M8 x 20 [51] and turn the Wrench [702] until the
Bracket Stop [88] is aligned with the groove of the Arbor Shaft [76] while pushing the Bracket Stop [88].
Then loosen the Bolt (Left Hand) W/Washer M8 x 20 [51] and remove the Bolt (Left Hand) W/Washer M8 x 20
[51], outside Arbor Collar [52], TCT Saw Blade [701], inside Arbor Collar [52].
3. Put the Cutter Shaft Guard [26] back into position and tighten the Counter Hd. Screw M5 x 12 [25].
Fig. 7
--- 9 ---