Assembly - Yamaha YB50 Service Manual

FRONT FORK

ASSEMBLY

Reverse the disassembly procedure. Bear in
mind the following points.
NOTE:
• When assembling the fork, ensure that the
following new parts are used.
• Oil seal
• Mudguard
• Sliding metal
• Ensure that all components are clean before
assembly.
1. Install:
• Shock absorber rod
• Oil lock piece (left side)
• Bar
• Copper washer (new)
• Bolt (shock absorber rod)
Bolt (hydraulic rod):
23 Nm (2.3 m • kg, 17 • lb)
LOCTITE®
NOTE:
Tighten the bolt (hydraulic rod) while suppor-
ting the bar with the T-handle
port .
T-handle:
90890-01326
Support:
90890-01294-A
2. Install:
• Oil seal
Use a counterbalance for installing fork
seals and an adaptor
Counterbalance for installing oil
seals:
90890-01184
Adaptor:
90890-01186
NOTE:
Before installing the oil seal, apply grease
with a lithium soap base on the edges of
same.
ATTENTION:
Ensure that the numbered side of the seal
is facing upwards.
6-16
CHAS
and the sup-
.